Avaya 8800 Troubleshooting Manual page 239

enable
mode <tx|rx|both|rxFilter|
txFilter|bothFilter>
remote-mirror-vlan-id
<0-4094>
Use the information in the following table to help you use the mirror-by-port command.
mirror-port <1-383>
<portList>
monitor-mlt <1-383>
<1-256>
monitor-port <1-383>
<portList>
monitor-vlan <1-383>
<0-4094>
Example of a simple mirroring configuration
Procedure steps
1. Create the port mirroring instance. Traffic passing port 7/1 is mirrored to port 7/2:
Troubleshooting
Variable
Variable
mirror-by-port 3 in-port 7/1 out-port 7/2
Value
monitor-vlan <0-4094>
•
mirroring VLAN ID from 0 to 4094.
• out-port <portList>
mirroring port.
Enables or disables a mirroring instance already
created in the mirror-by-port table.
Sets the mirroring mode. The default is rx.
• tx mirrors egress packets.
• rx mirrors ingress packets.
• both mirrors both egress and ingress packets.
• rxFilter mirrors and filters ingress packets. If
you use the rxFilter option with an R series
module, you must use an ACL-based filter.
• txFilter mirrors and filters egress packets.
• bothFilter mirrors and filters both egress and
ingress packets.
Sets the remote mirror VLAN ID.
Value
Modifies the mirrored port.
Modifies the monitoring MLT;
specifies the mirroring MLT ID.
Modifies the monitoring ports.
Modifies the monitoring VLAN.
Port mirroring configuration
specifies the
specifies the
<1-256>
July 2013 239