Configuring Port Mirroring - Avaya 8800 Troubleshooting Manual
Ethernet routing switch
Hide thumbs
Also See for 8800:
- Planning and engineering, network design (327 pages) ,
- Planning and engineering (306 pages) ,
- Configuration manual (226 pages)
Table of Contents
Advertisement
Software troubleshooting tool configuration using CLI
config filter acl
<acl-id> ace <ace-id>
remove-mirror-dst
config filter acl
<acl-id> set global-
action <none|mirror|
count|mirror-count|
ipfix|mirror-ipfix|
count-ipfix|mirror-
count-ipfix>
show diag mirror-by-
port
show filter acl debug
[<acl-id>] [<ace-id>]
Configuring port mirroring
Use port mirroring to aid in diagnostic and security operations.
Connect the sniffer (or other traffic analyzer) to the output port, you specify with out-port
<value>.
Procedure steps
1. Create a port mirroring instance:
148
Troubleshooting
Command
config diag mirror-by-port <id> create in-port <value> [out-
port <value>] [mode <value>] [enable <value>] [remote-mirror-
vlan-id <value>] [mirroring-mlt <value>] [mirroring-vlan
<value>]
<id> specifies the mirror-by-port entry ID in the range of 1 to 383.
Comments? infodev@avaya.com
Parameter
debug [count <value>]
[copytoprimarycp <value>]
[copytosecondarycp <value>] [mirror
<value>] [mirroring-dst-ports
<value>] [mirroring-dst-vlan <value>]
[mirroring-dst-mlt <value>]
info
mirroring-dst-ports <port>
mirroring-dst-vlan <vid>
mirroring-dst-mlt <mid>
July 2013
Advertisement
Table of Contents
Troubleshooting
