Mode
Enable
RemoteMirrorVlanId
MirroringVlanId
MirroringMltId
Configuring ACLs for mirroring
Use the ACL global action of mirroring to mirror packets for any ACE that matches a particular
packet.
Prerequisites
• The ACT exists.
• The ACT is applied.
• The ACL exists.
Procedure steps
1. In the navigation tree, open the following folders Configuration > Security > Data
2. Click ACL Filters.
3. Click the ACL tab.
Troubleshooting
Variable
Path.
Specifies the traffic direction of the packet being
mirrored:
• tx mirrors egress packets.
• rx mirrors ingress packets.
• both mirrors both egress and ingress packets.
• rxFilter mirrors and filters ingress packets.
• txFilter mirrors and filters egress packets.
• bothFilter mirrors and filters both egress and ingress
packets.
If you use the rx option with an R series module, you must
use an ACL-based filter.
Enables or disables this port mirroring instance. The
default value is Enable.
Specifies the virtual local area network (VLAN) ID to
which mirrored packets must be send for remote
mirroring. If set, this VLAN ID is used in the mirror tag of
the remote mirrored packet.
Specifies the destination VLAN ID.
Specifies the destination multilink trunk ID.
Configuring ACLs for mirroring
Value
July 2013
81