Avaya 8800 Troubleshooting Manual page 181

Method 1
In this solution, PCAP is configured to capture all packets on port interface 2/10 and packets
are saved on a PCMCIA device. The file containing captured packets is then copied using FTP
for analysis at a later time.
Procedure steps
1. Enable PCAP in receive mode on R1, port interface 2/10, to capture all ingress
2. Configure PCAP parameters:
3. Enable PCAP:
4. Show PCAP statistics:
5. Disable PCAP:
6. Copy the captured packets:
Troubleshooting
packets:
config ether 2/10 pcap enable true
config diag pcap auto-save true file_name pcap_test.cap
device pcmcia
config diag pcap enable true
show diag pcap stats
config diag pcap enable false
copy PCAP00 /pcmcia/pcap_test.cap
You can also use FTP:
PCAP configuration
July 2013 181