Using Wsp Dump Commands - Avaya 8800 Troubleshooting Manual

11. Verify that the wireless tunnel is added to the VLAN that is mapped or what is

Using WSP dump commands

Use the show commands to locate the general problem area and then use the dump commands
to get more detailed information as to why a WSP may be failing.
Procedure
1. From the WSP, get information on which WCP is managing the WSP:
2. Dump the mobility agent (ma) information to get general information on packets
Troubleshooting
(CLI) show wireless-switch fdb-entry [vid <value>] [mac
<value>]
(ACLI) show wireless switch mac-address-entry [vid <value>]
[mac <value>]
configured in the VLAN reservation in case of L3 Roaming. The wireless tunnel
appears like any other port member except it uses a WT-n designation.
(CLI) show vlan info
(ACLI) show vlan members
(CLI) dump wireless mcp info
(ACLI) dump wireless mcp
Note:
The Connection Status entry is very important because it tells you if the
connection between the WCP and WSP is established or not. Verify that the
connection status is established.
exchanged between the WCP and this WSP or more specific information on APs,
mobility switches (WSP), packet statistics, reset packet statistics, timers, VLANs
advertised, VLAN maps, and VLAN servers:
(CLI) dump wireless ma info
(ACLI) dump wireless ma
dump wireless ma ap [<mac>]
dump wireless ma ms [<mac>]
dump wireless ma pkt-stats
dump wireless ma reset-pkt-stats
dump wireless ma timers
(CLI) dump wireless ma vlan-advertised <mac> [<name>]
Troubleshooting WSP problems
July 2013 433