Avaya 8800 Troubleshooting Manual page 187

Variable definitions
Use the information in the following table to help you use the ping <HostName/
ipv4address/ipv6address> command.
-d
-s
-I <value>
-t <value>
count <value>
datasize <value>
interface-port <value>
interface-mgmt <value>
interface-vlan <value>
interface-tunnel
<value>
scopeid <value>
source <value>
vrf <value>
Use the information in the following table to help you use the pingipx <ipxhost>
command.
Troubleshooting
<prefix/len> specifies the IPv4 address and prefix length; <lsp-name>
specifies the name of the label-switched path.
Variable Value
Sets the ping debug flag. In debug mode, the ping
reply includes additional information about the device
being pinged.
Specifies that the IPv4 or IPv6 ping should be
retransmitted at continuous intervals at the interval
defined by -I <value>.
Specifies the interval between ping retransmissions
from 1 to 60 seconds.
Specifies the no-answer timeout from 1 to 120
seconds.
Specifies the number of times to ping the device from
1 to 9999. The default is 1.
Specifies the size of the ping packet in octets, either
16 to 4076, or 16 to 65487. The default is 16 octets.
Specifies the interface slot/port number.
Specifies the interface Ethernet management port
number.
Specifies the interface VLAN ID (1 to 4094).
Specifies the interface tunnel ID (1 to 2000).
Specifies the circuit scope ID for IPv6 from 1 to
9999.
Specifies the source IP address for use in IP VPN
pings.
Specifies the VRF instance by VRF name.
Running a ping test
July 2013 187