Extending System Message Control - Avaya 8800 Troubleshooting Manual

Variable definitions
Use the information in the following table to complete the sys msg-control command.
<cr>
action <suppress-msg|
send-trap|both>
control-interval <1-30>
max-msg-num <2-500>

Extending system message control

Use the force message control option to extend the message control feature functionality to
the software and hardware log messages.
To enable the message control feature, you must specify an action, control interval, and
maximum message number. After enabling the feature, the log messages, which get repeated
and cross the maximum message number in the control interval, trigger the force message
feature. You can either suppress the message or send a trap notification, or both.
Prerequisites
• Access Global Configuration mode.
Procedure steps
Configure the force message control option by using the following command:
Troubleshooting
Variable
Activates system message control. Enabling this
command suppresses duplicate error messages.
Configures the message control action. The default
value is suppress-msg.
Configures the message control interval in minutes.
The valid options are 1 to 30. The default value is 5.
Configures the number of occurrences of a message
after which the control action happens. To set the
maximum number of occurrences, enter a value from
2 to 500. The default values is 5.
Extending system message control
Value
July 2013 331