Avaya 8800 Troubleshooting Manual page 138

Software troubleshooting tool configuration using CLI
Configure the Route Switch Processor (RSP) packet tracing to observe the behavior of the
RSP on each R and RS/8800 module. The RSP is the programmable Application Specific
Integrated Circuit (ASIC) that controls the ports and traffic flow.
Procedure steps
Important:
The CLI command accepts only a single port.
1. Enable the RSP ingress packet tracing by using the following command:
2. Confirm the configuration by using the following command:
3. Disable the RSP ingress packet tracing by using the following command:
138 Troubleshooting
config rsp-trace ingress-pkt-trace port <value> state enable
[interval <value>]
OR
Enable the RSP egress packet tracing by using the following command:
config rsp-trace egress-pkt-trace port <value> state enable
[interval <value>]
Note:
If you use the egress-packet-trace feature on a BEB switch interface that
is not SPBM enabled, the MAC-in-MAC header appears in the trace because the
packet was captured prior to the egress RSP stripping off the MAC-in-MAC
header.
config rsp-trace info
Note:
Only the ports in lanes on which the trace is enabled are displayed
config rsp-trace ingress-pkt-trace port <value> state disable
[interval <value>]
OR
Disable the RSP egress packet tracing by using the following command:
config rsp-trace egress-pkt-trace port <value> state disable
[interval <value>]
Comments? infodev@avaya.com
July 2013