Configuring Remote Mirroring - Avaya 8800 Troubleshooting Manual

Software troubleshooting tool configuration using Enterprise Device Manager
DstPortList
DstVlanId
DstMltId
IpfixState
RedirectNextHopIpv6

Configuring remote mirroring

Use remote mirroring to monitor many ports from different switches using one network probe
device.
Procedure steps
1. From the Device Physical View tab, select a port.
2. In the navigation tree, open the following folders Configuration > Edit > Port.
3. Click General.
4. Click the Remote Mirroring tab.
5. To add an entry, click Insert.
6. Select Enable.
7. Choose the mode.
8. Type the source MAC address (optional).
9. Type the destination MAC address.
10. Select a VLAN from the list (optional).
11. Click Insert.
Variable definitions
Use the information in the following table to help you configure remote mirroring.
86 Troubleshooting
Variable
If you enable mirroring, ensure that you configure the
appropriate parameters:
• For R and RS/8800 modules in Rx mode: DstPortList,
DstVlanId, or DstMltId.
• For R modules in Tx mode: configure the Edit,
Diagnostics, Port Mirrors tab.
Specifies the ports to which to mirror traffic.
Specifies the VLAN to which to mirror traffic.
Specifies the Multilink Trunking (MLT) group to which to
mirror traffic.
Specifies whether IPFIX is enabled or disabled.
Redirects matching IPv6 traffic to the next hop.
Comments? infodev@avaya.com
Value
July 2013