Avaya 8800 Troubleshooting Manual page 401

Job aid: show ip mroute-hw command output
Use the information in the following table to help you understand the show ip mroute-hw
command output.
Table 23: show ip mroute-hw group-trace and group-prune-state output fields
group-trace
GROUP ADDRESS
SOURCE ADDRESS
SENDING SUBNET
TOTAL SESSIONS
IN VLAN
IN PORT
OUT PORT
OUT PORT
group-prune-state
GROUP ADDRESS
SOURCE ADDRESS
Troubleshooting
Variable
Field
The IP multicast group address for the multicast stream.
The IP addresses of the sources on this particular subnet
sending traffic to the multicast group for the selected entry in
the Mroute-HW table.
The network address of the source subnet that has sources
sending IP multicast traffic to the group address.
One session includes a combination of group address,
subnet, and ingress VLAN information. The total number of
sessions indicates how many sources in the same subnet are
sending traffic for the given group address and ingress
VLAN.
The ingress VLAN ID where the traffic emanates for the
multicast stream.
The corresponding ingress port in the multicast stream
selected from the Mroute-HW table.
All the egress VLANs for the particular multicast stream
selected from the Mroute-HW table.
The corresponding ports for the particular multicast stream
selected from the Mroute-HW table.
The IP multicast group address for the multicast stream.
The IP addresses of the sources on this particular subnet
sending traffic to the multicast group for the selected entry in
the Mroute-HW table.
Value
• When you use it by itself, the output includes all the
group entries found in the hardware records.
• When you follow the command with
the output includes all the entries corresponding to
the specified group address.
Description
Viewing multicast routes
grp <value>,
July 2013 401