Avaya 8800 Troubleshooting Manual page 250

Software troubleshooting tool configuration using ACLI
Prerequisites
• Access Global Configuration mode.
Procedure steps
1. To create a capture filter, enter the following command:
2. Configure the filter action:
3. Use the following variable definitions table to define the match parameters; for
4. Enable the filter:
5. Ensure the configuration is correct:
Variable definitions
Use the information in the following table to help you use the pcap capture-filter
<1-1000> command.
<cr>
action <capture|drop|
trigger-on| trigger-
off>
250 Troubleshooting
pcap capture-filter <1-1000>
pcap capture-filter <1-1000> action <capture|drop|trigger-
on|trigger-off>
example:
pcap capture-filter 1 dscp 60 to 63
pcap capture-filter <1-1000> enable
show pcap capture-filter [<1-1000>]
Variable
Comments? infodev@avaya.com
Creates a new PCAP filter.
Determines the action taken by the filter.
• capture indicates that the packet is captured.
• drop indicates that the packet is dropped.
• trigger-on indicates to start capturing the packet
when a packet matches this filter. PCAP is enabled
globally and the trigger filter is disabled.
• trigger-off indicates to stop capturing the packet
when a packet matches this filter. PCAP is disabled
globally and the trigger filter is disabled.
Value
July 2013