Upper layer troubleshooting
3. To verify whether the maximum BFD session number limit is reached, enter the
BFD session flaps
If the BFD session flaps, perform the following steps:
Procedure steps
1. To verify whether the multiplier parameter is 3 or higher, enter the following CLI
2. If the multiplier parameter is less than 3, to change it to 3 or higher, enter the
442
Troubleshooting
enter the following ACLI command:
show ip ospf neighbor
A BGP BFD session cannot be created until the BGP peer is established.
following CLI commands:
show ip bfd info show ports info vlacp
OR
enter the following ACLI commands:
show ip bfd show vlacp interface
The maximum number of total BFD and VLACP sessions cannot exceed 256.
command:
config {ethernet <portlist> | vlan <vid>} ip bfd info
OR
enter the following ACLI command:
show ip bfd interfaces {<port-type> <portlist> | vlan <vid>}
following CLI command:
config {vlan <vid> | ethernet <portlist>} ip bfd multiplier
<2-20>
OR
enter the following ACLI command:
(config-if)# ip bfd [port <portlist> | vlan <vid>] multiplier
<2-20>
Comments? infodev@avaya.com
July 2013