2. Display the ingress packet tracing by using the following command:
Variable definitions
Use the information in the following table to help you complete the preceding procedure
steps.
end-pkt <value>
pkt-id <value>
port <value>
start-pkt <value>
Dumping specified ERCD records
Dump a specified Enterprise RSP Control Driver (ERCD) record to view that record.
Troubleshooting
Display the specific ingress RSP packet by using the following command:
dump rsp-trace ingress-display-pkt port <value> pkt-id
<value>
dump rsp-trace ingress-pkt-trace port <value> [start-pkt
<value>] [end-pkt <value>]
OR
Display the egress packet tracing by using the following command:
dump rsp-trace egress-pkt-trace port <value> [start-pkt
<value>] [end-pkt <value>]
Variable
Value
Specifies the packet ID of the last packet to
display.
value specifies the packet ID as an integer in the
range of 1–1024.
Specifies the ID as an integer of the packet to
display.
value specifies the packet ID as an integer in the
range of 1–1024.
Specifies a port in the lane for which to display
the trace.
Specifies the packet ID of the first packet to
display.
value specifies the packet ID as an integer in the
range of 1–1024.
Dumping specified ERCD records
July 2013
141