Configuring Snmp Target Table Parameters - Avaya 8800 Troubleshooting Manual

parms <Target Name> new-
parms <value>
retry <Target Name> new-
retry <value>
taglist <Target Name> new-
taglist <value>
timeout <Target Name> new-
timeout <value>
Example of configuring an SNMP target table
Procedure steps
Create the target parameter ID (TparamV2) and target address ID (TAddr1), as well
as the other target parameters:
config snmp-v3 target-addr create Taddr1 198.202.188.207:162 TparamV2
timeout 1500 retry 3 taglist DefTag mask ff:ff:00:00:00:00 mms 484

Configuring SNMP target table parameters

Configure the target table to set parameters such as SNMP version and security levels. The
target table contains the security parameters for SNMP.
Prerequisites
Important:
Release 3.3 and Release 3.5 support only SNMPv1 or SNMPv2c trap configurations. When
you upgrade to Release 5.0, the trap configurations are in SNMPv1/SNMPv2c/SNMPv3.
Procedure steps
1. Configure SNMP target table parameters:
Troubleshooting
Variable
Although the maximum value for the MMS is
2,147,483,647, the device supports the maximum SNMP
packet size of 8192 (8K).
Specifies a new string value that identifies target address
table entries.
Specifies a new number of retries to attempt if a response
is not received for a generated message.
Specifies a new list of tag values.
Specifies a new maximum route trip time required to
communicate with the transport address.
Configuring SNMP target table parameters
Value
July 2013 287