Chapter 14: Log Configuration Using Enterprise Device Manager; Configuring The System Log - Avaya 8800 Troubleshooting Manual
Ethernet routing switch
Hide thumbs
Also See for 8800:
- Planning and engineering, network design (327 pages) ,
- Planning and engineering (306 pages) ,
- Configuration manual (226 pages)
Table of Contents
Advertisement
Chapter 14: Log configuration using
Use log files and messages to help perform diagnostic and fault management functions.
Configuring the system log
Use the system log to track all user activity on the switch. The system log can send messages
to up to ten syslog hosts.
Procedure steps
1. In the navigation tree, open the following folders: Configuration > Edit >
2. Click System Log.
3. Select Enable.
4. Configure MaxHosts and Header as required.
5. Click Apply.
Variable definitions
Use the information in the following table to help you configure the system log operational
parameters.
Enable
MaxHosts
Troubleshooting
Enterprise Device Manager
Diagnostics.
Variable
Enables or disables the syslog feature. When enabled,
this feature sends a message to a server on a network
that is configured to receive and store diagnostic
messages from this device. You can configure the type
of messages to send.
Specifies the maximum number of remote hosts
considered active and able to receive messages from
the syslog service.
Value
July 2013
277
Advertisement
Table of Contents
Troubleshooting
