Showing The Spbm Multicast Database - Avaya 8800 Troubleshooting Manual

Multicast troubleshooting using CLI
EXPIR
PROT

Showing the SPBM multicast database

You can determine the database used by the SPBM multicast module by using the following
procedure:
Procedure steps
Show the SPBM multicast database by using the following command:
show isis spbm ip-multicast-route [all | info | vlan <0–4094> |
vrf <vrfName> | vsn-isid <1– 16777215>]
Job aid: show isis spbm ip-multicast-route command
The following table describes fields for this command.
Table 28: show isis spbm ip-multicast-route command
VRF Source
Group
VSN-ISID
Data ISID
BVLAN
408 Troubleshooting
Field
check, but can be accepted on multiple interfaces (for
example, in CBT).
Indicates the minimum amount of time remaining
before this entry ages out. The value 0 indicates that
the entry is not subject to aging.
Indicates the outgoing mechanism through which the
switch learns this route. For IP multicast over SPBM,
this value is sb-access or spb-network. Spb-access
indicates the datastream learned was from the UNI
ports. Spb-network indicates that the datastream
learned was from the SPBM cloud.
Field
Specifies the IP address of the Global Routing Table
Specifies the IP multicast group for which this entry
specifies a next hop on an outgoing interface
Specifies the VSN I-SID
Specifies the VRF ID for the multicast route
Specifies the backbone VLAN
Comments? infodev@avaya.com
Description
Description
July 2013