Running An Ipv6 Traceroute Test - Avaya 8800 Troubleshooting Manual

Software troubleshooting tool configuration using ACLI
Prerequisites
• Access Privileged EXEC mode.
Procedure steps
To use traceroute, enter the following command:
traceroute <A.B.C.D> [<1-1464>] [-m <1-255>] [-p <0-65535>] [-
q <1-255>] [-w <1-255>] [-v] [source <WORD 1-256>] [vrf <WORD
0-64>]
Variable definitions
Use the information in the following table to help you use the traceroute <A.B.C.D>
command.
-m <1-255>
-p <0-65535
-q <1-255>
-v
-w <1-255>
<1-1464>
source <WORD 1-256>
vrf <WORD 0-64>

Running an IPv6 traceroute test

Use traceroute to determine the route packets take through a network to a destination.
262 Troubleshooting
Variable
Comments? infodev@avaya.com
Value
Specifies the is maximum time-to-live (TTL) (1 to
255).
Specifies the base UDP port number (0 to 65535).
Specifies the number of probes per TTL (1 to 255).
Specifies verbose mode (detailed output).
Specifies the wait time per probe (1 to 255).
Specifies the size of the probe packet (1 to 1464).
Specifies the source IP address for use in IP VPN
traceroutes.
Specifies the VRF instance by VRF name.
July 2013