Enabling Multicast Routing Process Statistics; Determining The Protocol Configured On The Added Vlan - Avaya 8800 Troubleshooting Manual
Ethernet routing switch
Hide thumbs
Also See for 8800:
- Planning and engineering, network design (327 pages) ,
- Planning and engineering (306 pages) ,
- Configuration manual (226 pages)
Table of Contents
Advertisement
Multicast troubleshooting using EDM
Enabling multicast routing process statistics
To provide additional troubleshooting information, you can enable the collection of multicast
routing process statistics. These statistics are not related to the interface (port) statistics.
Rather, the statistics are displayed based on VRF and multicast group classification. To
configure multicast routing process statistics, perform the following procedure. (To display the
collected statistics, you must use the CLI or ACLI.)
Procedure steps
1. In the navigation tree, open the following folders Configuration > IP.
2. Click Multicast.
3. Click the Multicast Stats tab.
4. Select the Enabled check box, and then click Apply.
Determining the protocol configured on the added VLAN
The protocol configured on the added VLAN can be one of the following values:
• snoop
• snoop-spb
• routed-spb
• pim
Procedure steps
1. In the navigation tree, open the following folders: Configuration > IP > IGMP.
2. Click the Interface tab.
392
Troubleshooting
The protocol is shown under the Mode column.
Comments? infodev@avaya.com
July 2013
Advertisement
Table of Contents
Troubleshooting
