Configuring The Remote Host Address For Log Transfer - Avaya 8800 Troubleshooting Manual

Log configuration using the ACLI
show logging file [tail] [category <WORD 0-100>] [severity
<WORD 0-25>] [CPU <WORD 0-25>] [name-of-file <WORD 1-99>]
[save-to-file <WORD 1-99>]
Variable definitions
Use the following table for help with the show logging file command.
category <WORD
0-100>
CPU <WORD 0-25>
name-of-file
<WORD 1-99>
save-to-file
<WORD 1-99>
severity <WORD
0-25>

Configuring the remote host address for log transfer

Configure the remote host address for log transfer. The system transfers the current log file to
a remote host when the log file size reaches the configured maximum size.
326 Troubleshooting
Filters and list the logs according to category. Specify a string
length of 0–100 characters. Categories include SNMP, EAP,
RADIUS, RMON, WEB, STG, IGMP, HW, MLT, FILTER, QOS,
SW, CPU, IP, VLAN, IPMC, DVMRP, |IPX, IP-RIP, MPLS,
OSPF, |PIM, POLICY, RIP. To specify multiple filters, separate
each category by the vertical bar (
FILTER|QOS .
Filters and list the logs according to the SF/CPU that generated
it. Specify a string length of 0–25 characters. To specify multiple
filters, separate each SF/CPU by the vertical bar (
example, CPU5|CPU6 .
Displays the valid logs from this file. For example, /pcmcia/
logcopy.txt. You cannot use this command on the current log
file—the file into which the messages are currently logged).
Specify a string length of 1–99 characters.
Redirects the output to the specified file and remove all
encrypted information. The tail option is not supported with the
save-to-file option. Specify a string length of 1–99
characters.
Filters and list the logs according to severity. Choices include
INFO, ERROR, WARNING, FATAL. To specify multiple filters,
separate each severity by the vertical bar (
ERROR|WARNING|FATAL
Comments? infodev@avaya.com
| ), for example, OSPF|
|
), for
| ), for example,
.
July 2013