Setting In-Band Management Ip Address Parameters From The Ip.cfg File On A Usb Device - Avaya 5900 Series Quick Start Configuration

Ethernet routing switch
Hide thumbs Also See for 5900 Series:
Table of Contents

Advertisement

Configuring management IP addresses using ACLI
Setting in-band management IP address parameters from
the ip.cfg file on a USB device
If the switch does not obtain an in-band management IP address through BootP, you can load the IP
address and optionally new switch software and configuration from the USB memory device using
the ip.cfg file.
Note:
The file name, ip.cfg, is case-insensitive.
If a properly formatted file exists on a USB port, the switch uses that ip.cfg as the first option,
rather than the last. You can specify one or more of the optional parameters in the ip.cfg file. All
of the parameters are optional.
The following table describes the ip.cfg file parameters:
Parameter
IP <A.B.C.D> | <WORD>
Mask <xx.xx.xx.xx>
Gateway <A.B.C.D> | <WORD>
SNMPread <string>
SNMPwrite <string>
VLAN <number>
USBdiag <string>
USBascii <string>
USBagent <string>
NEXTIP, NEXTMask, and NEXTGateway
Note:
If you download an ASCII file or diag/image with an ip.cfg file, the specific ASCII file or diag/
image must be present on the USB device.
October 2015
Description
Specifies the IP address for the switch. A.B.C.D is
IPv4 address, WORD is IPv6 address.
Specifies the IPv4 network mask. Example:
255.255.255.0
Specifies the default gateway. A.B.C.D is IPv4
address, WORD is IPv6 address.
Specifies the SNMP read community string.
Example: public
Specifies the SNMP write community string.
Example: private
Specifies the management VLAN-ID. Example:
VLAN 1
Specifies the filename of the diagnostic image to
load from the USB. Example: vsp7000/
vsp7000_10.0.1.10.bin
Specifies the filename of the ASCII config file to load
from the USB. Example: customer1.cfg
Specifies the filename of the agent image to load
from the USB and specifies IPs for next boot.
Example: vsp7000/vsp7000_10.0.1.0.img
Specifies IP addresses, nework mask, and gateway
to be used once the switch is booted.
Quick Start Configuration for Avaya ERS 5900 Series
Comments on this document? infodev@avaya.com
70

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

5928gts

Table of Contents