Avaya 8800 Troubleshooting Manual page 194

Software troubleshooting tool configuration using CLI
info
agent-comm-port <port>
agent ip-address <ipv4_addr | ipv6_addr>
agent port <port>
install-cert-file <file>
deinstall-cert-file <file>
oper-mode <enable | disable>
server ip-address <ipv4_addr | ipv6_addr>
[<ipv4_addr | ipv6_addr>]
194 Troubleshooting
Variable
Comments? infodev@avaya.com
Value
Displays current status of SLA Monitor.
Configures the port used for RTP and NTR
testing in agent-to-agent communication.
The default port is 50012. If you configure
this value to zero (0), the default port is
used.
Configures the agent IP address. You must
configure the IP address before the agent
can process received discovery packets
from the server. The default value is 0.0.0.0,
which causes the agent to use the device IP
address.
Configures the UDP port for agent-server
communication. The agent receives
discovery packets on this port. The default is
port 50011.
The server must use the same port.
Installs an SSL certificate. <file>specifies the
file name and path of the certificate to
install.
If you install a certificate on the agent, you
must ensure a matching configuration on the
server.
By default, the agent uses an Avaya SIP
certificate to secure communications with the
server.
Uninstalls an SSL certificate. <file>specifies
the file name and path of the certificate to
uninstall.
Enables or disables the SLA Monitor agent.
The default is disabled.
If you disable the agent, it does not respond
to discovery packets from a server.
If you disable the agent because of resource
concerns, consider changing the server
configuration instead, to alter the test
frequency or duration, or the number of
targets.
Restricts the agent to use of this server IP
address only. The default is 0.0.0.0, which
means the agent can register with any
server.
You can specify a secondary server as
well.
July 2013