Avaya 8800 Troubleshooting Manual page 270

SNMP trap configuration using Enterprise Device Manager
11. In the TMask box, type the mask.
12. In the MMS box, type the maximum message size.
13. Click Insert.
Variable definitions
Use the information in the following table to configure a target table.
Name
TDomain
TAddress
Timeout
RetryCount
TagList
Params
TMask
270 Troubleshooting
Variable
Specifies a unique identifier for this table. The name is
a community string.
Specifies the transport type of the address: ipv4Tdomain
or ipv6Tdomain.
Specifies the transport address in
xx.xx.xx.xx:portformat, for example: 10:10:10:10:162,
where 162 is the trap listening port on the system
10.10.10.10. You can also specify IPv6 addresses.
Specifies the maximum round trip time required to
communicate with the transport address. The value is in
1/100 seconds. The default is 1500.
After the system sends a message to this address, if a
response (if one is expected) is not received within this
time period, you can assume that the response is not
delivered.
Specifies the maximum number of retries if a response
is not received for a generated message. The count can
be in the range of 0 to 255. The default is 3.
Contains a list of tag values used to select target
addresses for a particular operation. A tag refers to a
class of targets to which the messages can be sent.
This parameter refers to a Tag value listed in the Notify
Table tab (Configuration > Edit > SnmpV3 > Notify
Table).
Contains SNMP parameters used to generate
messages to send to this transport address. For
example, to receive SNMPv2C traps, use TparamV2.
This parameter refers to a Name value listed in the
Target Params Table tab (Configuration > Edit >
SnmpV3 > Target Table > Target Params Table).
Specifies the mask. The value can be empty or in six-
byte hex string format. Tmask is an optional parameter
that allows an entry in the TargetAddrTable to specify
multiple addresses.
Comments? infodev@avaya.com
Value
July 2013