Configuring Snmp Notifications - Avaya 8800 Troubleshooting Manual

SNMP trap configuration using CLI
show snmp snmplog info
show snmplog file [tail]
[grep <value>]
show snmp-v3

Configuring SNMP notifications

Configure the notify table to select management targets to receive notifications, as well as the
type of notification to send to each management target.
Procedure steps
1. Create an SNMP notification by using the following command:
2. To specify the required tags for an existing notification, enter the following
3. To specify the required type for an existing notification, enter the following
4. Ensure that the configuration is correct:
284 Troubleshooting
Command
config snmp-v3 notify create <Notify Name> [tag <value>]
[type <value>]
command:
config snmp-v3 notify tag <Notify Name> new-tag <value>
command:
config snmp-v3 notify type <Notify Name> new-type <value>
config snmp-v3 notify info
show snmp-v3 notify
Comments? infodev@avaya.com
Parameter
fatal>] [<info|warning|error|
fatal>]
udp-port <port>
notify
ntfy-filter
ntfy-profile
target-addr
target-param
July 2013