Remote mirroring configuration navigation
•
Configuring remote mirroring
•
Example of remote mirroring configuration using ACLs
Configuring remote mirroring
Use remote mirroring to monitor many ports from different switches using one network probe
device.
For more information about configuring remote mirroring, see the Remote Port Mirroring
Technical Configuration Guide.
Procedure steps
1. Configure remote mirroring using the following command:
2. Use the following variable definitions table to configure any other parameters that
3. Ensure that the remote mirroring configuration is correct:
Variable definitions
Use the information in the following table to use the config ethernet <slot/port>
remote-mirroring command.
add-vlan-id <vlan-id>
create [enable <true|
false>] [mode <source|
termination>] [srcmac
Troubleshooting
config ethernet <slot/port> remote-mirroring create [enable
<true|false>] [mode <source|termination>] [srcmac <mac>]
[dstmac <mac>] [ether-type <ether-type>]
are required.
show port info remote-mirroring
Variable
on page 157
Specifies to which VLAN the remote mirroring
destination MAC address belongs. This must be
a port-based VLAN. Used only for Remote
Mirroring Termination (RMT) ports. When the
RMT port is removed from the last VLAN in the
list, RMT is disabled on the port.
Creates a remote mirroring entry for the port.
Create an entry before setting any remote
mirroring parameters on the port.
Remote mirroring configuration
on page 159
Value
July 2013
157