Avaya 8800 Troubleshooting Manual page 191

By default, ping snoop messages are echoed only to the serial console port. If you do not have
access to the serial port and are connecting via Telnet (or other means such as SSH or Rlogin),
to see the messages in your session, enter:
config log screen on
This setting is specific to the CLI session where it is executed. The command does not save
to the configuration file and when the CLI session is closed the setting is removed.
You can use two sessions with this command: in one session, configure the ping snoop
commands, and in the other session, issue the config log screen on command to see
the messages; when done, close the second session.
Procedure steps
1. Add the required ports to the ACL:
2. Enable the ACL:
3. Create an ACE:
4. Configure the ACE action:
5. Configure the destination IP address:
6. Configure the source IP address (optional):
7. Enable the ACE:
8. Ensure your configuration is correct:
Variable definitions
Use the information in the following table to help you use these commands.
Troubleshooting
config filter acl 4096 port add <ports>
config filter acl 4096 enable
config filter acl 4096 ace <ace-id> create
config filter acl 4096 ace <ace-id> action <permit|deny>
config filter acl 4096 ace <ace-id> ip dst-ip eq <ip addr>
config filter acl 4096 ace <ace-id> ip src-ip eq <ip addr>
config filter acl 4096 ace <ace-id> enable
config filter acl 4096 info
config filter acl 4096 port info
Configuring ping snoop for R series modules
July 2013 191