Avaya 8800 Troubleshooting Manual page 98

Software troubleshooting tool configuration using Enterprise Device Manager
TimeOut
ProbeCount
AdminStatus
DataFill
Frequency
MaxRows
StorageType
TrapGeneration
TrapProbeFailureFilter
TrapTestFailureFilter
Type
Descr
SourceAddressType
SourceAddress
98 Troubleshooting
Variable
Specifies the timeout value, in seconds, for a remote
ping operation. The default is 3 s.
Specifies the number of times to perform a ping
operation at a remote host. The default is 1.
Specifies the state of the ping control entry: enabled or
disabled.
Determines the data portion of a probe packet
Specifies the number of seconds to wait before repeating
a ping test. The default is 0.
Specifies the maximum number of entries allowed in the
PingProbeHistory table.
Specifies the storage type for this row.
Specifies when to generate a notification. The options
are:
• ProbeFailure—Generates a PingProbeFailed
• TestFailure—Generates a PingTestFailed notification.
• TestCompletion—Generates a PingTestCompleted
Specifies the number of successive probe failures that
are required before a pingProbeFailed notification is
generated.
Determines the number of probe failures that signal
when a test fails.
Selects or reports the implementation method used to
calculate ping response time.
Describes the remote ping test.
Specifies the type of the source address used at a
remote host when performing a ping operation.
Specifies the IP address (a.b.c.d) as the source address
in outgoing probe packets.
Comments? infodev@avaya.com
Value
notification subject to the value of
pingCtlTrapProbeFailureFilter. The object
pingCtlTrapProbeFailureFilter can be used to specify
the number of successive probe failures that are
required before a pingProbeFailed notification is
generated.
The object pingCtlTrapTestFailureFilter can be used to
determine the number of probe failures that signal
when a test fails.
notification.
July 2013