Avaya 8800 Troubleshooting Manual page 294

SNMP trap configuration using CLI
max-hosts <maxhost>
state <enable|disable>
Use the information in the following table to help you use the config sys syslog host
command.
address <ipaddr>
create
delete
facility <facility>
host <enable|disable>
info
maperror <level>
mapfatal <level>
mapinfo <level>
mapwarning <level>
severity <info|warning| error|
fatal> [<info|warning| error|
fatal>] [<info|warning| error|
fatal>] [<info|warning| error|
fatal>]
294 Troubleshooting
Variable
Specifies the maximum number of syslog hosts
supported. <maxhost> is the maximum number of
enabled hosts allowed (1 to 10).
Enables or disables sending syslog messages on the
switch.
Variable
Configures a host location for the syslog host. <ipaddr>
is the IP address of the UNIX system syslog host.
Creates a syslog host instance.
Deletes a syslog host.
Specifies the UNIX facility in messages to the syslog
host. <facility> is the UNIX system syslog host facility
(LOCAL0 to LOCAL7).
Enables or disables the syslog host.
Shows information about the syslog host configuration.
Specifies the syslog severity to use for Error messages.
<level> is one of {emergency|alert|critical|error|warning|
notice|info|debug}.
Specifies the syslog severity to use for Fatal messages.
<level>
warning|notice|info|debug}.
Specifies the syslog severity level to use for Information
messages. <level> is one of {emergency|alert|critical|
error|warning|notice|info|debug}.
Specifies the syslog severity to use for Warning
messages. <level> is {emergency|alert|critical|error|
warning|notice|info|debug}.
Specifies the severity levels for which to send syslog
messages for the specified modules. <severity> is the
severity for which syslog messages are sent.
Comments? infodev@avaya.com
Value
address is used in the IP header. If you configure
multiple circuitless IPs, the first circuitless IP configured
is used.
Value
is one of {emergency|alert|critical|error|
July 2013