Avaya 8800 Troubleshooting Manual page 267

agent-comm-port <0–65535>
agent ip address {A.B.C.D}
agent port <0–65535>
install-cert-file
oper-mode enable
server ip address {A.B.C.D} [{A.B.C.D}]
server port <0–65535>
Troubleshooting
Variable
Configuring the SLA Monitor agent
Value
Configures the port used for RTP and NTR
testing in agent-to-agent communication.
The default port is 50012. If you configure
this value to zero (0), the default port is
used.
Configures the agent IP address. You must
configure the IP address before the agent
can process received discovery packets
from the server. The default value is 0.0.0.0,
which causes the agent to use the device IP
address.
Configures the UDP port for agent-server
communication. The agent receives
discovery packets on this port. The default is
port 50011.
The server must use the same port.
Installs an SSL certificate.
WORD<0-128>specifies the file name and
path of the certificate to install.
If you install a certificate on the agent, you
must ensure a matching configuration on the
server.
By default, the agent uses an Avaya SIP
certificate to secure communications with the
server.
Enables the SLA Monitor agent. The default
is disabled.
If you disable the agent, it does not respond
to discovery packets from a server.
If you disable the agent because of resource
concerns, consider changing the server
configuration instead, to alter the test
frequency or duration, or the number of
targets.
Restricts the agent to use of this server IP
address only. The default is 0.0.0.0, which
means the agent can register with any
server.
You can specify a secondary server as
well.
Restricts the agent to use of this registration
port only. The default is 0, which means the
agent disregards the source port information
in server traffic.
The server must use the same port.
July 2013 267