Configuring Ace Debug Actions To Mirror - Avaya 8800 Troubleshooting Manual

Configuring ACE debug actions to mirror

Use debug actions to use filters for troubleshooting or monitoring procedures.
If you use the mirror action, ensure that you specify the mirroring destination: MLTs, ports, or
VLANs.
Prerequisites
• The ACE exists.
• Enter Global Configuration mode.
Procedure steps
1. Configure debug actions for an ACE using the following command:
2. Ensure the configuration is correct:
Variable definitions
Use the information in the following table to help you use the filter acl ace debug
<1-4096> <1-1000> commands.
copy-to-primary-cp
enable
copy-to-secondary-cp
enable
Troubleshooting
Variable
mirroring ports. See
mirror
filter acl ace debug <1-4096> <1-1000> [mirror enable]
[monitor-dst-ports <portList>] [monitor-dst-vlan <0-4094>]
[monitor-dst-mlt <1-256>]
<1-4096> specifies the ACL ID from 1 to 4096; <1-1000> specifies the ACE ID
from 1 to 1000.
show filter acl debug [<1-4096>] [<1-1000>]
Variable
Enables the ability to copy matching packets to the primary
(Master) CPU.
Enables the ability to copy matching packets to the
Secondary CPU.
Value
Configuring ACE debug actions to
on page 241.
Value
Port mirroring configuration
July 2013 241