Avaya 8800 Troubleshooting Manual page 139

Variable definitions
The following table describes variables that you enter in the config rsp-trace ingress-
pkt-trace port <value> state <value> or the config rsp-trace egress-
pkt-trace port <value> state <value> command.
port <value>
state <value>
[interval <value>]
Troubleshooting
Enabling and disabling the Route Switch Processor (RSP) packet tracing
Variable Value
Specifies the port on which to enable packet
tracing.
value specifies the number of the port in the format
of slot/port.
Important:
Although you specify only one port, the packet
tracing is enabled on all ports in that lane. The
info command displays all ports in that lane so
that you do not enable packet tracing on the
same RSP through a different port.
Specifies the state of the ingress or egress packet
tracing. By default the trace is enabled for 1
second. After 1 second, the trace is disabled
internally. An optional parameter, interval, is
provided to keep the trace enabled for the desired
number of seconds.
value specifies the state as enable or disable.
Important:
RSP packet tracing displays only the last 1024
packets captured.
Indicates the time interval for which the packet
tracing is to remain enabled.
value specifies a value of 1, 10, 30, 60, 120, or
300 seconds. The default value is 1 second.
The interval is an optional parameter. If you do not
configure the interval, the default value is 1
second. If you do configure the interval, the time
interval changes immediately. On all subsequent
occasions when you enable rsp-trace, if you do
not specify a new interval value, it is set to the
previously set interval value. This eliminates the
need to change the configuration every time you
use this command.
July 2013 139