Cannot Create A Pim Instance On A Vrf; Cannot Enable Pim On A Vlan Or Brouter Interface - Avaya 8800 Troubleshooting Manual

ip pim enable

Cannot create a PIM instance on a VRF

If you cannot create a PIM instance on a VRF, possible causes include the following:
• The VRF does not exist.
• The maximum PIM instance count is reached.
To troubleshoot, perform the following procedure.
Procedure steps
1. To verify that the VRF exists and that the total PIM instance count is 63 or less,
2. If the instance count is 64, to delete a PIM instance, enter the following command:

Cannot enable PIM on a VLAN or brouter interface

If you cannot enable PIM on a VLAN or brouter interface, a possible cause is that the VLAN
is associated with a VRF which does not have a PIM instance created. To troubleshoot, perform
the following procedure.
Procedure steps
1. To check the VRF association for the VLAN, enter the following CLI command:
Troubleshooting
enter the following CLI command:
show ip vrf info
OR
enter the following ACLI command:
show ip vrf
config ip vrf <vrf-name> pim delete
OR
From VRF Router Configuration mode, enter the following ACLI command:
no ip pim enable
show vlan info ip
Multicast virtualization
July 2013 383