Avaya 8800 Troubleshooting Manual page 85

RemarkDscp
RemarkDot1Priority
Police
RedirectNextHop
RedirectUnreach
EgressQueue
EgressQueue1g
EgressQueue10g
EgressQueueADSSC
StopOnMatch
Flags
Troubleshooting
Variable
Specifies whether the DSCP parameter marks nonstandard
traffic classes and local-use Per-Hop Behavior (PHB). The
default is disable.
Specifies whether Dot1 Priority, as described by Layer 2
standards (802.1Q and 802.1p), is enabled. The default is
disable.
Specifies the policer. Valid values range from 0 to 16383,
with zero (0) as the default. When policing is not desired,
set the value to zero.
Configure a policer using the QoS, Policy tab.
Redirects matching IP traffic to the next hop.
Configures the desired behavior for redirected traffic when
the specified next-hop is not reachable. The default value
is deny.
Specifies a 10/100/1000 Mbit/s module egress queue to
which to send matching packets.
If you specify a value greater than 8, it is not applied to
10/100/1000 Mbit/s module because this module supports
only 8 queues. However, the value is applied to the 1 Gbit/
s and 10 Gbit/s module types. The default value is 64.
Specifies a 1 Gbit/s module egress queue to which to send
matching packets. The default value is 64.
Specifies a 10 Gbit/s module egress queue to which to send
matching packets. The default value is 64.
Identifies the configured ACE ADSSC. The default is
disable.
Enables or disables the stop-on-match option. This option
specifies whether to stop or continue when an ACE that
matches the packet is found. When this ACE matches, a
match on other ACEs with lower priority is not attempted.
Specifies one of the following flag values:
• none—No action (default value).
• count—Enables or disables counting if a packet that
matches the ACE is found.
• copyToPrimaryCp—Enables or disables the copying of
matching packets to the primary CP.
• copyToSecondaryCp—Enables or disables the copying
of matching packets to the secondary CP.
• mirror—Enables or disables the mirroring of matching
packets to an interface.
Configuring ACEs for mirroring
Value
July 2013 85