Software troubleshooting tool configuration using ACLI
PCAP configuration
Use the Packet Capture Tool to aid in troubleshooting procedures. An active Secondary CPU
is required.
PCAP configuration navigation
•
Roadmap of PCAP ACLI commands
•
Accessing the Secondary CPU
•
Configuring PCAP global parameters
•
Enabling PCAP on a port
•
Configuring PCAP capture filters
•
Configuring VLAN MAC filters for PCAP
•
Using the captured packet dump
•
Copying captured packets to a remote machine
•
Resetting the PCAP DRAM buffer
•
Modifying PCAP parameters
Roadmap of PCAP ACLI commands
The following table lists the commands and their parameters that you use to perform the
procedures in this section.
Privileged EXEC mode
show pcap
244
Troubleshooting
Variable
on page 248
Command
Comments? infodev@avaya.com
a port-based VLAN. Used only for Remote
Mirroring Termination (RMT) ports. When the
RMT port is removed from the last VLAN in the
list, RMT is disabled on the port.
on page 244
on page 246
on page 246
on page 249
on page 252
on page 253
on page 254
on page 255
on page 255
Parameter
<cr>
capture-filter [id <1-1000>]
dump
Value
July 2013