Procedure steps
1. To check the VRF association for the VLAN, enter the following CLI command:
2. To ensure the VRF PIM instance is in SSM mode, enter the following CLI command:
Maximum number of PIM neighbors is reached
If the system has a maximum of 200 PIM neighbors, a warning message appears stating that
the PIM neighbor limit has been reached. To troubleshoot, perform the following procedure.
Procedure steps
1. To check which VRFs have active PIM neighbors, enter the following command
2. To lower the number of PIM neighbors, consider reorganizing the PIM domain,
Troubleshooting
show vlan info ip
OR
enter the following ACLI command:
show interface vlan ip
show ip pim info vrf <vrf-name>
OR
enter the following ACLI command:
show ip pim vrf <vrf-name>
using the CLI or ACLI:
show ip pim neighbor vrfids 0-255
potentially replacing PIM nodes with IGMP Snoop switches where acceptable.
Multicast virtualization
July 2013
385