Configuring An Snmp Host Target Address - Avaya 8800 Troubleshooting Manual

Variable definitions
Use the information in the following table to complete the config snmp-v3 notify
command.
create <Notify Name> [tag
<value>] [type <value>]
delete <Notify Name>
info
tag <Notify Name> new-tag
<value>
type <Notify Name> new-type
<value>

Configuring an SNMP host target address

Configure a target address to specify the transport addresses to use in the generation of SNMP
messages.
Procedure steps
1. Add an SNMP target address by entering the following command:
Troubleshooting
Variable
Creates an SNMP trap notification entry.
• <Notify Name> is the index of the notify table with a string
length of 1 to 32.
• tag <value> specifies the tag.
• type <value> can specify trap or inform.
Deletes an entry from the notify table.
Displays the notify table information.
Specifies the new notify tag for the entry in the notify
table.
Specifies the new notify type for the entry in the notify table.
The valid options are trap and inform.
Important:
You must include all of the required parameters in this command. If you do not
include them, the command is not parsed correctly and the traps are not sent to
the destination address. The later addition of these missing parameters does not
rectify the situation.
config snmp-v3 target-addr create <Target Name> <Ip
addr:port> <Target parm> [timeout <value>] [retry <value>]
Configuring an SNMP host target address
Value
July 2013 285