Using Bgp Debugging Commands - Avaya 8800 Troubleshooting Manual

Software troubleshooting tool configuration using ACLI
rp-adv
send
source <A.B.C.D>

Using BGP debugging commands

Use global and peers debug commands to display specific debug messages for your global
and peers BGP configuration, including the BGP neighbors.
You can use these commands to troubleshoot your BGP configuration.
For debug tips and mask information, see
Prerequisites
Access BGP Router Configuration mode.
Procedure steps
1. To display specific debug messages for your global BGP configuration, enter the
2. Display specific debug messages for your global BGP neighbors using the following
3. Display specific debug messages for BGP peers or peer groups using the following
4. You can also run BGP trace using the following command:
234 Troubleshooting
Variable
following command:
global-debug mask <WORD 1-100>
To remove specific debug messages use no global-debug mask <WORD
1-100>.
command:
neighbor-debug-all mask <WORD 1-100>
To remove specific debug messages use no neighbor-debug-all mask
<WORD 1-100>.
command:
neighbor <nbr_ipaddr|peer-group-name> neighbor-debug mask
<WORD 1-100>
Comments? infodev@avaya.com
Value
Displays RP advertisement debug traces.
Displays trace messages forwarded by the switch.
Displays debug traces from a specific source IP
address.
Job aid on page 145.
July 2013