SNMP trap configuration using the ACLI
Configuring an SNMP notify filter table
Configure the notify table to select management targets to receive notifications, as well as the
type of notification to send to each management target. For more information about the notify
filter table, see RFC 3413.
Prerequisites
• Access Global Configuration mode.
Procedure steps
1. Create a new notify filter table by using the following command:
2. Ensure that the configuration is correct:
Variable definitions
Use the information in the following table to complete the snmp-server notify-filter
command.
<WORD 1-32> <WORD
1-32>
316
Troubleshooting
snmp-server notify-filter <WORD 1-32> <WORD 1-32>
show snmp-server notify-filter
Variable
Creates a notify filter table.
If the Subtree OID parameter uses a + prefix (or no
prefix), this indicates include. If the Subtree OID uses the
- prefix, this indicates exclude.
Comments? infodev@avaya.com
• <WORD 1-32> specifies the name of the filter profile
with a string length of 1 to 32.
• The second <WORD 1-32> identifies the filter subtree
OID with a string length of 1 to 32.
Value
July 2013