Variable Definitions - Avaya 8800 Troubleshooting Manual

7. Verify the agent configuration:
Example
Configure the agent IP address, and then enable the SLA Monitor agent. Configure the agent
so that it only accepts registration packets from a specific server communicating on a specific
port. Verify the configuration.
ERS-8800:1# config
ERS-8800:1/config# slamon agent ip-address 192.0.2.1
ERS-8800:1/config# slamon oper-mode enable
ERS-8800:1/config# slamon server ip-address 192.0.2.25
ERS-8800:1/config# slamon server port 50156
ERS-8800:1/config# show slamon agent
==================================================================
==================================================================
SLAMon Operational Mode: Enabled
SLAMon Agent Address: 192.0.2.1
SLAMon Agent Port: 50011
SLAMon Agent Registration Status: Not Registered
SLAMon Registered Server Address: 0.0.0.0
SLAMon Registered Server Port: 0
SLAMon Server Registration Time: 0
SLAMon Configured Agent Address: 192.0.2.1
SLAMon Configured Agent Port: 0
SLAMon Configured Server Address: 192.0.2.25 0.0.0.0
SLAMon Configured Server Port: 50156
SLAMon Agent-To-Agent Communication Port: 50012
SLAMon Configured Agent-To-Agent Communication Port: 0
SLAMon Configured Agent Address Vrf Name:
Next steps
If you have configured SLA Monitor yet the agent is not functioning as expected, use the show
khi performance command to verify that the slamon task is running.
If the agent is not in the expected state, reset the system to start the agent.
If the agent task functions as expected, perform typical troubleshooting steps to verify agent
accessibility:
• Verify IP address assignment and port use.
• Ping the server IP address.
• Verify the server configuration.

Variable definitions

Use the data in the following table to use the slamon command.
Troubleshooting
config slamon install-cert-file <file>
show slamon agent
SLA Monitor Agent Info
Configuring the SLA Monitor agent
July 2013 193