Configuring An Snmp Notify Filter Table - Avaya 8800 Troubleshooting Manual

Procedure steps
Configure target table parameters:
config snmp-v3 target-param create TparamV2 mp--model snmpv2c sec-level
noAuthNoPriv sec-name readview

Configuring an SNMP notify filter table

Configure the notify table to select management targets to receive notifications, as well as the
type of notification to send to each management target. For more information about the notify
filter table, see RFC 3413.
Procedure steps
1. Create a new notify filter table by using the following command:
2. Ensure that the configuration is correct:
Variable definitions
Use the information in the following table to complete the config snmp-v3 ntfy-
filter command.
create <Profile Name> <subtree
oid> [mask <value>] [type
<value>]
Troubleshooting
config snmp-v3 ntfy-filter create <Profile Name> <subtree
oid> [mask <value>] [type <value>]
config snmp-v3 ntfy-filter info
show snmp-v3 ntfy-filter
Variable
Creates a notify filter table.
• <Profile Name> specifies the name of the profile with
a string length of 1 to 31.
• <subtree oid> identifies the filter subtree with a string
length of 1 to 32.
Configuring an SNMP notify filter table
Value
July 2013 289