Assigning Ip Parameters Using Enterprise Device Manager; Verifying Assigned Ip Address Is Reachable - Avaya Ethernet Routing Switch 3600 Series Manual

Installing ERS 3600 in an equipment rack
Property
Parity
Flow Control

Assigning IP parameters using Enterprise Device Manager

Procedure
1. Connect a computer to the switch through a data port using a standard RJ-45 network cable.
2. Open a Web browser on the attached computer.
3. Enter the factory default IP address of the switch in the following format: http://
<IPAddress>.
4. In the navigation pane of the Enterprise Device Manager Interface, click Administration >
Quick Start.
5. In the In-Band Stack IP Address dialog box of the IP/Community/Vlan work area, type a
switch or stack IP address.
6. In the In-Band Subnet Mask dialog box, type a subnet mask.
7. In the Default Gateway dialog box, type an IP address.
8. Click Apply.
Note:
For more information about switch configuration, see Quick Start Configuration for Avaya
Ethernet Routing Switch 3600 Series, NN47213-301.

Verifying assigned IP address is reachable

Before you begin
• Ensure you have assigned an IP address to the switch.
• Physically connect the switch to the network.
• Ensure the terminal from which you ping the switch is on the same network as the switch.
Procedure
Ping the 3600 Series switch from a terminal or workstation that is on the same network. If the
network device sends a ping reply, a message indicates that the specified IP address is alive and
can communicate with other devices.
January 2017
Value
None
None
Installing Avaya Ethernet Routing Switch 3600 Series
Comments on this document? infodev@avaya.com
34