System Recovery; Notes On Executing System Recovery; Procedure To Execute System Recovery - Agilent Technologies ENA Series User Manual

System Recovery

By executing system recovery, you can return the Windows operating system and the
firmware of the E5070A/E5071A to the state when you purchased it

Notes on executing system recovery

Executing system recovery causes the following:
o The following settings of the E5070A/E5071A are initialized.
•
•
•
o If the firmware has been updated after purchasing the E5070A/E5071A, the firmware
when you purchased the product
o The driver for the supported printer you installed is deleted.
Files you created using the save function (files in the D drive) are not affected, but we
recommend backing them up before executing system recovery for precautionary
purposes. For more information on backup, refer to "Making Backup Files" on page 366.

Procedure to execute system recovery

NOTE
You need the keyboard and the mouse for this operation.
Step 1. Shut down the E5070A/E5071A.
Step 2. Connect the keyboard and the mouse to the E5070A/E5071A.
Step 3. Press the standby switch of the E5070A/E5071A to turn it on.
Step 4. When the message in the figure below appears on the screen following the Agilent's logo
screen (white screen), immediately press
NOTE After several seconds, the next screen appears automatically even if you do not press any
key, so do not miss it.
If the above message does not appear, the instrument is at fault; contact your local Agilent
customer center listed at the end of this manual or distributor.
*1.If the hard disk failed and has been replaced after purchase, the state when the replacement
Chapter 12
Setting and Using the Control and Management Functions
Network setting
GPIB setting
Printer setting
*1
was performed is recovered.
is recovered.
on the keyboard.
System Recovery
*1
.
265