Texas Instruments TMS320C6201 Reference Manual page 446

Mechanical Dimensions for the 14-Pin Emulator Connector
15.8 Mechanical Dimensions for the 14-Pin Emulator Connector
Figure 15–6. Pod/Connector Dimensions
2.70
0.90
Emulator Cable Pod
15-12
The JTAG emulator target cable consists of a 3-foot section of jacketed cable,
an active cable pod, and a short section of jacketed cable that connects to the
target system. The overall cable length is approximately 3 feet 10 inches.
Figure 15–6 and Figure 15–7 (page 15-13) show the mechanical dimensions
for the target cable pod and short cable. Note that the pin-to-pin spacing on
the connector is 0.100 inches in both the X and Y planes. The cable pod box
is nonconductive plastic with four recessed metal screws.
4.50
Short, Jacketed Cable
Note: All dimensions are in inches and are nominal dimensions, unless otherwise specified.
9.50
Connector
Refer to Figure 15–7.