Designing for JTAG Emulation
This chapter assists you in meeting the design requirements of the XDS510
emulator with respect to JTAG designs and discusses the XDS510 cable
(manufacturing part number 2617698-0001). This cable is identified by a label
on the cable pod marked JTAG 3/5V and supports both standard 3-volt and
5-volt target system power inputs.
The term JTAG, as used in this book, refers to TI scan-based emulation, which
is based on the IEEE 1149.1 standard.
Topic
15.1 Designing Your Target System's
Emulator Connector (14-Pin Header)
15.2 Bus Protocol
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
15.3 IEEE 1149.1 Standard
15.4 JTAG Emulator Cable Pod Logic
15.5 JTAG Emulator Cable Pod Signal Timing
15.6 Emulation Timing Calculations
15.7 Connections Between the Emulator and the Target System
15.8 Mechanical Dimensions for the 14-Pin Emulator Connector
15.9 Emulation Design Considerations
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Designing for JTAG Emulation
Chapter 15
Page
15-2
15-3
15-3
15-4
15-5
15-6
. . . . . .
15-8
. . . .
15-12
15-14
15-1