Copier/Printer; Entering Energy Saver Mode - Gestetner A193 Service Manual

ENERGY SAVER MODES

8.3 COPIER/PRINTER

S tand-by M ode
M ain
S witch
O ff
A uto S hut O ff M ode
Fusing Lam p O ff
⇒
E nergy S aver LE D O ff
C P U /G A P D O ff
S ystem 5V O ff

Entering energy saver mode

The machine enters energy saver level 1 or 2 in the same way as the copier
only configuration.
What happens in energy saver modes 1 and 2
The behavior of the machine in energy saver levels 1 and 2 is the same as in
the copier only configuration (fusing lamp at low temperature).
However, when the auto shut off timer runs out, the machine enters energy
saver mode level 3 instead of auto shut off mode.
What happens in energy saver level 3
When the machine enters energy saver level 3, the fusing lamp turns off
completely. However, the system 5 volt supply stays on. The recovery time
from this level is the same as for recovery from auto shut off mode. The
machine will print incoming print jobs from a computer.
From energy saver level 3, the machine returns to standby mode in the same
way as from energy saver levels 1 and 2.
(A193)
C lear M ode/E nergy S aver K ey
S ystem A uto R eset Tim er
C lear M ode/E nergy S aver K ey
O riginal in the D F
D F lifted up
C lear M ode/E nergy S aver K ey
O riginal in the D F
D F lifted up
M ain
S w itch
O n
M ain S w itch O ff
2-66
A uto E nergy S aver M ode
E nergy S aver Level 1 or 2
Fusing lam p to low tem perature
E nergy S aver LE D O n
C P U /G A P D O n
S ystem 5V O n
A uto S hut O ff
Tim er
A uto E nergy S aver M ode
E nergy S aver Level 3
Fusing Lam p O ff
E nergy S aver LE D O n
C P U /G A P D O n
S ystem 5V O n
Rev. 2/28/97
A193D548.wmf
SM