Chrysler 2005 Crossfire SRT6 Service Manual page 1950

9 - 26 ENGINE - ELECTRICAL DIAGNOSTICS
(P0106) MAP SENSOR PERFORMANCE (CONTINUED)
4.
SENSOR GROUND CIRCUIT OPEN
Turn the ignition off.
Disconnect the MAP Sensor harness connector.
Disconnect the PCM C3 harness connector.
Note: Check connectors — Clean/repair as necessary.
Measure the resistance of the Sensor Ground circuit from the MAP
Sensor harness connector to the PCM C3 harness connector.
Is the resistance below 5.0 ohms?
Yes >> Replace and program the Powertrain Control Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/POWERTRAIN
REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> Repair the Sensor Ground circuit for an open.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
5.
CHECK FOR ENGINE OIL SENSOR DTC
With the ignition on.
With the DRB III , read PCM DTCs.
Are any Engine Oil Sensor DTCs present?
Yes >> Go To 6
No >> Go To 12
CONTROL MODULE -
ZH