Chrysler 2005 Crossfire SRT6 Service Manual page 1937

ZH
(P0102) MASS AIR FLOW CIRCUIT (CONTINUED)
5.
5-VOLT SUPPLY CIRCUIT OPEN
Turn the ignition off.
Disconnect the PCM C3 harness connector.
Note: Check connectors — Clean/repair as necessary.
Measure the resistance of the 5-Volt Supply circuit from the PCM C3
harness connector to the MAF Sensor harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go To 6
No >> Repair the 5-Volt Supply circuit for an open.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
6.
5-VOLT SUPPLY CIRCUIT SHORT TO GROUND
With the ignition off.
Measure the resistance between ground and the 5-Volt Supply circuit.
Is the resistance above 100 kohms?
Yes >> Go To 7
No >> Repair the 5-Volt Supply circuit for a short to ground.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
ENGINE - ELECTRICAL DIAGNOSTICS 9 - 13