Chrysler 2005 Crossfire SRT6 Service Manual page 1921

ZH 8W-97 POWER DISTRIBUTION 8W - 97 - 5
INSTALLATION
1. Install the relay control module harness connectors to the relay control module (1).
2. Install the relay control module into the control module box, pushing the relay control module down until the clips
snap into place.
3. Install the control module box lid.
4. Connect the negative battery cable.
UNDERHOOD ACCESSORY FUSE BLOCK
DESCRIPTION
The Underhood Accessory Fuse Block houses many of the fuses for the vehicles electrical system. The Underhood
Accessory Fuse Block is located on the left side of the engine compartment just in front of the brake booster. The
Underhood Accessory Fuse Block can not be serviced it must be replaced as a unit.
OPERATION
All of the circuits entering and leaving the Underhood Accessory Fuse Block do so through seperate wires. There
are NO seperate wiring harness connectors that connect to the Underhood Accessary Fuse Block. Each circuit is
connected individually to the Underhood Accesssory Fuse Block, and held in place by the use of retention combs.