Chrysler 2005 Crossfire SRT6 Service Manual page 1923

ZH
INSTALLATION
1. Install the harness connectors to the underhood accessory fuse block.
2. Push the underhood accessory fuse block down into the box until the rear tabs and the front two tabs (1) connect.
3. Install the lid.
4. Connect the negative battery cable.
FUSE BLOCK
DESCRIPTION
The Fuse Block is part of the Illumination Control Module. A knob on the face of the module controls the exterior
lighting functions. The exterior lighting and headlamp switch portions of the Illumination Control Module cannot be
adjusted or repaired. If faulty or damaged, the entire module assembly must be replaced as a unit. (Refer to 8 -
ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/HEADLAMP SWITCH - REMOVAL).
OPERATION
The Fuse Block on the side of the Illumination Control Module houses the Fuses for the following:
• Fuse 2. Brake Lamp
• Fuse 3. Right High Beam/High Beam Indicator Lamp
• Fuse 4. Reverse Lamp/Turn Signal Lamp/Rear View Mirror
• Fuse 5. Left High Beam
• Fuse 6. Right Low Beam
• Fuse 7. Right Parking/Tail Lamp Side Marker
• Fuse 8. Left Low Beam
• Fuse 9. Fog Lamp
• Fuse 10. Left Parking/Tail Lamp Side Marker
• Fuse 11. License Plate/Instrument Cluster Lighting/Symbol Lighting
• Fuse 12. Rear Fog Lamp (Export Only)
8W-97 POWER DISTRIBUTION 8W - 97 - 7