Chrysler 2005 Crossfire SRT6 Service Manual page 1952

9 - 28 ENGINE - ELECTRICAL DIAGNOSTICS
(P0106) MAP SENSOR PERFORMANCE (CONTINUED)
9.
5-VOLT SUPPLY CIRCUIT OPEN
Turn the ignition off.
Disconnect the PCM C3 harness connector.
Note: Check connectors — Clean/repair as necessary.
Measure the resistance of the 5-Volt Supply circuit from the MAP Sen-
sor harness connector to the PCM C3 harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go To 10
No >> Repair the 5-Volt Supply circuit for an open.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
10.
5-VOLT SUPPLY CIRCUIT SHORT TO GROUND
With the ignition off.
Measure the resistance between ground and the 5-Volt Supply circuit.
Is the resistance above 100 kohms?
Yes >> Go To 11
No >> Repair the 5-Volt Supply circuit for a short to ground.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
ZH