Chrysler 2005 Crossfire SRT6 Service Manual page 1931

ZH
(P0040) 1/1 AND 2/1 O2 SENSOR HARNESS CONNECTORS REVERSED (CONTINUED)
2.
POWERTRAIN CONTROL MODULE
Turn the ignition off.
Verify that the upstream O2 Sensors harness connectors are con-
nected to the correct O2 Sensor and repair as necessary.
Turn the ignition on.
With the DRB III , erase all PCM DTCs.
Turn the ignition off, then back on.
Start and let the engine idle.
If the DTC does not set right away, it may be necessary to test drive
the vehicle.
With the DRB III , read PCM DTCs.
Did DTC, (P0040) 1/1 AND 2/1 O2 SENSOR HARNESS CONNEC-
TORS REVERSED, set again?
Yes >>
Note: Before continuing, verify the front O2 Sensor harness connectors are connected to the correct O2
Sensor with no damage or terminal push out. Repair as necessary.
If OK, replace and program the Powertrain Control Module. (Refer to 8 - ELECTRICAL/ELECTRONIC
CONTROL MODULES/POWERTRAIN CONTROL MODULE - REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> Go To 3
3.
INTERMITTENT WIRING AND CONNECTORS
The conditions necessary to set this DTC are not present at this time.
Note: Check connectors — Clean/repair as necessary. Poor pin to terminal connections can set DTCs. Using
the wiring diagram/schematic as a guide, inspect the wiring and connectors specific to this DTC. Wiggle the
wires while checking for shorts and/or open circuits.
Note: Check for any Technical Service Bulletins that may apply.
Were any problems found?
Yes >> Repair as necessary.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for
a possible intermittent condition.
ENGINE - ELECTRICAL DIAGNOSTICS 9 - 7